BOB SpaceWire
. The SpaceWire BOB is thought to help the operators to acquire with probes the signals for a fast debugging at electrical and protocol level...
. The SpaceWire BOB is thought to help the operators to acquire with probes the signals for a fast debugging at electrical and protocol level...
The Dbub BOB is a pass-through breakout box for general signals diagnostic. The signals routing is done on printed circuit board on a six layers PCB and the lines can be interrupted via toggle switches on the top of the box. 37pin and 78pin are available BOB could be delivered with short cable adapters High Quality Connectors stainless steel shell Mini Banana Jack (2mm) Jack spacing of 12mm Toggle switches Signal routing is done on PCB Box is made of...
The LOADS Box is in charge to simulate the typical consumption of electronics’ equipment....
The HTR module is a 3U, 12HP plug-in, in charge to to simulate 4 independent heater interfaces...
The TSMsim module is a 6U, 4HP plug-in, in charge to simulate four static temperature values for both TSM type 1 (ESCC4006-14, Issue 8, Variant 08, G15K4D489) and TSM type 2 (PT2000) thermistors on each channel....
The HPC module is a 6U, 4HP plug-in, in charge to to generate 12 HV-HPC pulsed outputs ...
The TSMacq module is a 6U, 4HP plug-in, in charge to acquire temperature sensors ...
The BSM module is a 6U, 4HP plug-in, in charge to acquire and time tag, simultaneously, 10 BSM inputs...
The ASM module is a 6U, 4HP plug-in, in charge to acquire simultaneously 8 ASM inputs...